The Electron Controls CAN Mini I/O Interface enables interaction between CAN bus signals/messages and real-world signals or devices.
Whether it is a simple switch, warning light, or indicator or perhaps something more complex such as a frequency input or output, wheel speed sensors, thermocouples, etc... the CAN Mini I/O can handle the job.
CAN data can be fed to other devices, such as an ECU. Input signals can be broadcast on the CAN bus in a message format.
Typical Application:
The Mini I/O Interface reads RX-8 ABS wheel speed data from the vehicle's 500k CAN bus and outputs a frequency signal (which simulates a raw wheel speed sensor signal) to a Bosch Motorsport ECU. As an option, any of the four wheel speeds can be output, or perhaps the average of the two front wheels, or the higher of the two.
Passing the data to the dashboard allows for accurate pit speed limiter operation in any gear.
The CAN Mini I/O is housed in a compact enclosure (2.5 x 1.6 x 1.2 inches) for easy installation.
|
Standard CAN bus compatibility: • ISO-11898 standard physical layer • Supports 250k, 500k, and 1000k bit rates • Supports CAN1.2, CAN 2.0A, and CAN 2.0B • DeviceNet data bytes filter support • Standard and extended data frames (11-bit or 29-bit) • Support for SAE J1939 protocol |
Hardware Interface Options: • 2 - Open Collector Outputs (5v/12v pullup, 100mA) • 1 - Opto-Isolated Input (max 30v) • 1 - PWM Output (10-bit resolution, configurable freq.) • up to 4 - Analog Inputs (10-bit ADC conversion) • up to 7 - Digital Inputs (TTL or Schmitt logic) • up to 7 - Digital Outputs |
System Capacity:
• Input Masks and Message Filters for greater efficiency
Design services are available to fit most installations